Boom

I remember seeing a thread a long time ago about power drawbars for the B'port, but I can't find it. What is the best one to use on a series 1 M/C?

I also made the 3/8" Harbor Freight impact tool based drawbar for my Series 1 mill and it works wonderfully. I have never needed to use a hammer on the drawbar since installation.

i recall the the bridgeports and clones do not have captive drawbars and that makes power draw bars difficult in the bridgeport world.

Is the driver an air impact or an air ratchet? Do you have a pneumatic schematic to share? I'm guessing that the cylinder engages the socket with the drawbar and the springs …

Until I can decide what kind of power drawbar to buy, I came up with this approach to attaching and removing R-8 tooling. A Milwaukee right angle attachment and Milwaukee …

Until I can decide what kind of power drawbar to buy, I came up with this approach to attaching and removing R-8 tooling. A Milwaukee right angle attachment and Milwaukee …

This power drawbar is very well made and shipped quickly. We installed it on a Bridgeport Series 1 CNC mill our company rebuilt. Because our mill is cnc we put the spring on top (so the …

After falling ill, I was struggling to change the tooling on my Bridgeport mill so decided to build a pneumatic power draw-bar. There are plenty of great videos on You Tube and other sites for research, So I decided to try …

This power draw bar will fit Bridgeport and most other imports. Also included is a pressure regulator unit, you simply bolt the power draw bar to the top of your mill using two 1/4-20 bolts, and connect the air supply, the …

It's easy to drop it on the drawbar with a 3/4" socket overhead without looking. The trigger of the impact driver rests against the Bridgeport head, and a bit of pressure activates it. I keep the impact driver in a little holster on …